Airbag SRS OBD2 Reset Tool for VW and Audi

$24.99
(2 reviews) Write a Review
SKU:
AIRRESET-VW
Availability:
Ships within 24 hours

How does the Airbag Reset Tool work?

After an accident that deploys the airbag, all Audi-VW airbag systems are locked. Even after small accident, the airbag sensor will write to the internal memory an error message "crash data stored". When this occurs, you would normally have to replace the expensive sensor. With our Reset Tool, you can reset and repair the airbag computer in minutes!

  • Reset and repair the airbag computer in minutes!
  • Standalone unit eliminates the hassle of needing an extra computer
  • No additional power required; plugs into your OBDII port
  • No need to remove the airbag sensor. Fully automatic sensor type detection
  • Pays for itself with one use

 

Compatible With:
1. Supports the new Audi airbag sensors (with hc12cpu or CR16 PLCC44) 1999-2002 crash data and DTC65535 (Controller Malfunction) erase, such as: 4B0959655G, 4B0959655J,4B0959655C, 8L0959655G, 4D0 959 655 J, 8D0 959 655 J , 8D0 959 655 F, 8D0 959 655 M, etc

2. Supports the new Airbag sensor (with CR16 80QFP) from VW-Audi (A3, A4, A6, A8 2002-2005, Touareg) crash data and DTC65535 (Controller Malfunction) erase, such as 4B0959655Q ,etc.

3. Supports crash data and fault memory erase:

AUDI A4, A6, A8 1994-1997: Airbag V BOSCH : 8A0 959 655 C (Bosch 0 285 001 038), 8A0 959 655 K (Bosch 0 285 001 155), 8A0 959 655 K (Bosch 0 285 001 151) - Crash data erase, Fault erase;

AUDI A3, A4, A6, A8 1999: Airbag 7 BOSCH - 4B0 959 655 C, 4B0 959 655 J, 4D0 959 655 C, 4D0 959 655 H, 8D0 959 655 C, 8D0 959 655 L, 8L0 959 655 F - all Bosch Airbag 7 - Crash data erase, Fault erase; 

Audi A2, A3, A4, A6, A8 - 1999: Airbag 8 BOSCH - Crash data erase, Fault erase (can't erase "Controller Malfunction" for this moment); ?VW - Golf III, Passat B4, Sharan - 1J0 909 603 SIEMENS - Crash data erase, Fault erase; 

VW - Golf IV, Passat B5 - 1J0 909 609, 1J0 909 607 - SIEMENS - Crash data erase, Fault erase; 

VW - Golf IV, Passat B5 - 3B0 959 655 B, 8L0 959 655 A - all BOSCH - Crash data erase, Fault erase; 

VW - Golf IV, Passat B5, Sharan - 6Q0 909 605 A, 6Q0 909 605 B - SIEMENS - Crash data erase, Fault erase; 

VW - Golf IV, Passat B5, Sharan - 1C0 909 605 C, 1C0 909 605 F, 1C0 909 605 H, 6Q0 909 605 C - SIEMENS - Crash data erase, Fault erase; 

VW - Passat B6 - new SIEMENS - Crash data erase, Fault erase.

 

Operating Instructions

  • Connect the tool to your vehicles OBDII diagnostic port
  • The Right button “C-Clear” is for airbag "crash data" erase. Push this button once and wait for the yellow light start to flash.
  • After 15 second the green light on will indicate that the crash data was successfully erased
  • The Red “Fail” light will turn on if erasing was not successful.
  • Left “D-Clear” button is for erasing airbag fault memory or errors. If the airbag warning
    lamp goes OFF and immediately back ON, evaluate airbag error memory using a VAG diagnostic tool

 

2 Reviews Hide Reviews Show Reviews

  • 5
    worked perfectly for 65535 error

    Posted by Unknown on 7th Oct 2017

    This is the one to buy. I decided to hold on to the device in case another cold snap causes the controller to throw the error again. Prompt delivery through OBDInovations.

  • 5
    Works

    Posted by Unknown on 14th Sep 2014

    Got the job done