The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

O2 Oxygen Sensor Extension Cable for 1987-2010 Ford Mustang V6 3.8L 24"

$14.99
(No reviews yet) Write a Review
SKU:
O2EXT-87-09-MUSTANG-24-1

When you install most aftermarket headers, it moves the oxygen sensor bungs towards the rear of the car, farther from the factory harness, so extensions are required. These extensions make the installation hassle free by not having to cut and splice the factory wiring. It also makes removing aftermarket headers much easier.

  • Compatible with 1987-2010 Ford Mustang V6 3.8L
  • Uses the same connectors, terminals and seals as the OEM wiring harness
  • Made with High Temperature, cross-linked, polyethylene TXL wire in the correct gauge
  • Hassle free installation without having to cut/splice into your factory wiring harness
  • Retain a clean factory appearance
  • Assembled in the USA
  • Quantity: 1 Extension Cable

Compatible with:

  • 1987-2010 Ford Mustang Base V6 / GT / Cobra / Mach 1 / Bullitt (Front or Rear Sensor)